Acoustica - Software should be easy to use

Rendering dropouts

Support and feedback for Beatcraft.

Moderators: Acoustica Dan, Acoustica Greg, Acoustica Chris, Acoustica Eric

Posts: 1
Joined: Fri Jul 15, 2011 8:44 am

Rendering dropouts

Postby Leo2112 » Fri Jul 15, 2011 8:51 am

Greetings all:

I hope someone can help, because I'm at my wts end. I've been using Beatcraft for a while now, but reently every time I create a rendering, there's a a measure or two of dropout somewhere in the middle of the track. Usually it comes after a crash symbol, a measure or two of dead air then the track starts up again. But it's not like the sound abruptly cuts out; it's more like purposefully placing a rest measure in the middle of the track, which I have not done.

I've tried adjusting the buffer, adding a new track where the dropout occurs, rendering under a different file format . . . nothing works. It's very aggravating. any suggestions will be greatly appreciated.



User avatar
Acoustica Eric
Site Admin
Posts: 5785
Joined: Wed Mar 22, 2006 4:30 pm
Location: Michigan, USA


Postby Acoustica Eric » Sat Jul 16, 2011 9:51 am

If you are using multiple tracks in the sequencer window, try condensing down to as few as possible. I did an entire cd using beatcraft, never using more than one track.

Return to “Beatcraft”

Who is online

Users browsing this forum: No registered users and 1 guest