Interface Selection

Support and feedback for Acoustica's Mixcraft audio mixing software.

Moderators: Acoustica Chris, Acoustica Eric, Acoustica Dan, Acoustica Greg

Post Reply
Posts: 32
Joined: Wed Apr 23, 2014 6:52 am

Interface Selection

Post by slh2536 » Tue Apr 29, 2014 7:16 am

I'm looking for a inexpensive Interface that will plug into my USB to get my latency down to real time. Can someone point me in the right direction. Thanks!

User avatar
Posts: 66
Joined: Fri Jan 07, 2011 1:22 pm
Location: NW Wisconsin

Re: Interface Selection

Post by Bucktail » Tue Apr 29, 2014 7:45 am

I use a Presonus AudioBox USB. Very durable unit that works well to fill my need with this little hobby of recording music with Mixcraft.

User avatar
Acoustica Greg
Posts: 20888
Joined: Wed Mar 01, 2006 5:30 pm
Location: California

Re: Interface Selection

Post by Acoustica Greg » Tue Apr 29, 2014 8:55 am


Did you try WaveRT in exclusive mode? Is that option available to you?

You should note that if you buy an audio interface, you'll also need a new microphone, because you won't be able to plug your USB microphone into the audio interface. Unless there's an audio interface that supports that. I'm not aware of any.


User avatar
Posts: 2548
Joined: Sun May 06, 2012 1:59 am
Location: Wiltshire, UK

Re: Interface Selection

Post by trevlyns » Tue Apr 29, 2014 2:17 pm

also have to plug Focusrite scarlett 2i2

Renowned for great pre amps and latency free monitoring through the cans.
Keep on trackin'

Official OFC™ Founding Member

Win 10 64 bit; MX9 Pro; Intel core i-5 @ 3.30 GHz; 4 GB RAM
I started out with nothing - and still have most of it left! - Seasick Steve

Posts: 8
Joined: Mon Apr 21, 2014 11:19 am

Re: Interface Selection

Post by SlimGotDatFie256 » Wed Apr 30, 2014 11:56 am

trevlyns wrote:also have to plug Focusrite scarlett 2i2

Renowned for great pre amps and latency free monitoring through the cans.
I was just about to post a thread like this. My question is which would be a better buy? The Focusrite Scarlet or the M-Audio MidiSport 2x2. Any advice would be appreciated. Also it may answer the original question in this thread.

User avatar
Posts: 3538
Joined: Wed Dec 12, 2012 12:23 pm
Location: San Antonio, TX

Re: Interface Selection

Post by outteh » Wed Apr 30, 2014 12:27 pm

Best advice is to review the specifications for each, see which one offers the best performance. Other features to look for is separate audio channel outputs so you can switch between different speakers or setups to compare sounds, separate headphone volume adjustment, at least up to 48 kHz and 24 bit recording capability, number of microphone and instrument inputs, depending on your need. Be careful on the latency specifications, check out the support and current audio driver support and see if they say it is compatible for Windows 8, which would indicate they keep up with audio driver support. :D

User avatar
Mark Bliss
Posts: 6750
Joined: Fri Jan 20, 2012 3:59 pm
Location: Out there

Re: Interface Selection

Post by Mark Bliss » Wed Apr 30, 2014 7:17 pm

Its really hard to give advise on this subject. Everyone's needs, budgets and desires vary. The market is fluid, and no one person can really have experience in the many options. Point is, you really need to do your homework before choosing.

Also, As Greg as attempted to point out, there are also other options, depending on your specific needs and existing rig. I have lost track of the multiple threads, was the OP using a USB adapter or a dedicated USB mic? One thing that hasn't been fully discussed, if you only need a mic, and only need one channel.
I have used a USB mic that has on board output that is capable of very low latency monitoring.

As for audio interfaces, personally I have had good experience with an economy Tascam unit, and a Presonus unit. Beyond that I can only share trends I have seen in various discussions in multiple home recording and producing forums. Based on the many discussions I have read, I would suggest avoiding the M-Audio units. Far to many consistent comments on problems with drivers, reliability issues and so forth. On the other hand, I have read regular comments recommending both Focusrite and Presonus units.

But again, much of the decision depends on your specific needs. I would strongly recommend researching the topic and accumulating info from multiple sources.
Here is one that recently popped up. Scroll down to the bottom of the page for some topical guidance that may lead to further questions to research. ... -guide/151
Stay in tune, Mark


Posts: 2322
Joined: Wed Mar 07, 2007 7:00 pm
Location: near Music City,USA

Re: Interface Selection

Post by gypsy101 » Wed Apr 30, 2014 11:49 pm

slh2536 wrote:I'm looking for a inexpensive Interface that will plug into my USB to get my latency down to real time. Can someone point me in the right direction. Thanks!
if it's only a latency issue I'd look into the root cause first.
are you using ASIO4ALL?
buffer settings?
what OS are you using? (this affects WaveRT latency).

what insturments do you plan to use and how many @ once?

I won't name brands but my advice is to go w/ more inputs than you think you'll need.
want 1 go 2 minimum,want 2 go 4,etc.

User avatar
Posts: 161
Joined: Mon Mar 24, 2014 6:22 am

Re: Interface Selection

Post by FlyingsCool » Thu May 01, 2014 10:48 am

I recently purchased my first audio interface after a lot of research.

I was originally thinking I wanted to spend as little as possible for a decent quality interface, so I was looking for probably a 2 input interface. At first I, after a lot of study of the various inexpensive interfaces, I was thinking the Steinberg UR22. But I read of users having issues with it's USB drivers, and of some sort of quality issue (I forget what). Also, just about all of the 2 input interfaces are bus powered, which often means low gain on the preamps, and also they will be unable to properly power mics requiring phantom power. I also read a lot of people having problems overdriving the preamps on the 2i2 when recording guitar.

All my study finally led me to the Focusrite Scarlett 6i6, which has two mic preamps, two line inputs, and 2 digital spdf inputs. With the 4 analog inputs, I can record my guitar with a direct line, and up to 3 mics to record my voice and 1 or 2 mics for the guitar as well, which is just what I really wanted. It is also wall wart powered, as opposed to bus powered, so it can easily handle phantom powered mics should I ever need it. The final kicker was that I found it on sale at Guitar Center for $175.

I've only made a couple of recordings using it so far, but it's worked fine so far with my Windows 7 Pro HP Elitebook 8560w with 16GB mem and a 2.4 (Turbo up to 3.4) GHz processor laptop (and Mixcraft 6).

Latency was fine in both its native ASIO an Windows RT interface modes.

Just my 2 cents answering your question regarding a new low latency interface. I would, however, figure out why you have a high latency on your current interface as the previous posters asked, before you invest in a new interface.

Post Reply