LINE 6 TONE PORT UX2 and mixcraft 3

Support and feedback for Acoustica's Mixcraft audio mixing software.

Moderators: Acoustica Chris, Acoustica Eric, Acoustica Dan, Acoustica Greg

Post Reply
teljax
Posts: 149
Joined: Fri May 26, 2006 9:34 am
Location: Pasadena California USA

LINE 6 TONE PORT UX2 and mixcraft 3

Post by teljax » Thu Apr 26, 2007 3:32 pm

Im considering buying LINE 6 TONE PORT UX2. Before I buy it I figure its best to stop by here and make sure it works well with mixcraft 3.
Has anyone here used LINE 6 TONE PORT UX2 with mixcraft 3?

whanbury
Posts: 3
Joined: Mon Apr 23, 2007 8:09 pm

Using the TonePort

Post by whanbury » Fri Apr 27, 2007 2:55 pm

Greetings, I had the toneport 2 for a while with an earlier version of Mixcraft (new ver 3 is incredible by the way!) and I found a lag in the response time for recording. I know all about memory buffers etc. but I couldn't warm up to the Line6. I returned it and bought a Behringer UB1002FX instead, and that serves me well. It was only $89 and has built in effects. I'm probably going to get an even smaller Behringer without effecs for recording because I want to become more adept at using the built in effects on the Mixcraft console. Good luck!
Who let all these people in my room?!?

Post Reply