7 to 10 problem

Support and feedback for Acoustica's Mixcraft audio mixing software.

Moderators: Acoustica Greg, Acoustica Eric, Acoustica Dan, rsaintjohn

Post Reply
magician
Posts: 86
Joined: Fri Mar 26, 2010 11:39 pm
Location: UK

7 to 10 problem

Post by magician »

Hi Guys. Finally changed from widows 7 to 10. I can record all on board Mixcraft instruments, just not vocals. Mic signal is getting to the track ok, but when I try to record it says "I might not have permission? Anyone know what this problem is, all settings seem to be ok?
User avatar
Mark Bliss
Posts: 7313
Joined: Fri Jan 20, 2012 3:59 pm
Location: Out there

Re: 7 to 10 problem

Post by Mark Bliss »

I assume you are using the on board sound card and mic input.

Go to Windows privacy settings, and look for microphone.
Make sure its set to allow apps to use the mic.

https://forums.acoustica.com/viewtopic. ... ic#p126670
Stay in tune, Mark

My SOUNDCLOUD Page
magician
Posts: 86
Joined: Fri Mar 26, 2010 11:39 pm
Location: UK

Re: 7 to 10 problem

Post by magician »

Thanks Mark, but after checking, that wasn't it. I'm using a Behringer u-phoria UMC204HD. The signal was getting to Mixcraft 9 pro ok, but trying to record was impossible. All I got was that "needing permission" notice. Tried all sorts of settings and I have managed to get it working now. Not 100% sure it's working properly as on occasion the transport won't run......a Windows 10 nightmare. LOL
From one oldie to another, thanks for the advice though. :D
Post Reply