Page 1 of 1

Acoustica Beatcraft Question

Posted: Wed Jun 26, 2019 2:21 am
by Urkis
I've tried lots of different plugins and stuff but Beatcraft seems the be the cheapist option but i've encountered a problem.

When i'm writing up the drum parts i have to separate them into individual projects for each time change.

So say if i had a song which was in these sections:
1: 120bpm
2: 155bpm
3: 132bpm

Then i'd have to make 3 different Beatcraft projects. This would'nt be a problem because i'd just render them all and connect them in Cubase but when i render them the end of the Wave files sometimes cut off and finish a second to early.

The question is how do you change the Time signiture for each section in Beatcraft.

Re: Acoustica Beatcraft Question

Posted: Thu Jun 27, 2019 4:21 pm
by Acoustica Greg
Hi,

Right-click and select Flags > Tempo Flags.

Greg

Re: Acoustica Beatcraft Question

Posted: Tue Aug 20, 2019 12:52 am
by Varyu
I've encountered the same exact problem and I'm pretty sure it's impossible to change the time signature. However, seeing as the sound does cut off at the end occasionally, I add a few blank drum patterns at the end of the sequence so the sounds have time to finish echoing and the track itself will some much more fluid when you connect them.

Re: Acoustica Beatcraft Question

Posted: Tue Aug 20, 2019 9:12 am
by Acoustica Greg
Varyu wrote:I've encountered the same exact problem and I'm pretty sure it's impossible to change the time signature. However, seeing as the sound does cut off at the end occasionally, I add a few blank drum patterns at the end of the sequence so the sounds have time to finish echoing and the track itself will some much more fluid when you connect them.
Hi,

The only way to change the time signature is to adjust the number of beats per measure, possibly in combination with changing the tempo.

Greg