Thalassa77 episode 5
https://www.youtube.com/watch?v=qV_VxEAXXDU
Making a bell sound in Synth1.
Basic saw sound.
1. initial sound, turn off LFO 1 & 2, Chorus, Tempo
2. Amplifier> A=0, D=71 (60%), S=0, R=80 (60%), gain=107, vel = 21
3. OSC1> Sine, OSC2 >Triangle, Key Shift +24, mix 100 : 0, OSC2 pitch -21, fine +61
4. FM> 64 (50%)
5. Filter> ADSR = 0, amt 0, type BP12, frq 64 (50%), trk 54 (40%)
6. Use an fx reverb(Acoustica Reverb)
**** Approximately ****
7. Turn On Chorus> time 1.90, depth 87, rate 0.36, fdbk 36%, levl 127.
8. Turn On Delay> time (1)/3, sprd 0.0 : 1.6, fdbk 40, d/w 23%, toned (127 = no echo__0 > echo).
Tips from Thalassa77
"You will get better results if OSC2 tune is not directly proportional to OSC1."
I think it means, you will get better sounds if OSC2 does not sound like OSC1.
Turn off Tempo and Chorus, play around with OSC2 pitch and fine to get a different ''sound".
Filter> frq for a darker or lighter "sound".
Making a bell sound.
Moderators: Acoustica Greg, Acoustica Chris, Acoustica Eric, Acoustica Dan, rsaintjohn