- s-l300.jpg (5.1 KiB) Viewed 14813 times
Printing on discs leave ink on clear plastic ring.
Moderators: Acoustica Greg, Acoustica Eric, Acoustica Dan
Printing on discs leave ink on clear plastic ring.
Hi the discs I use are these below.
But everytime I print if always leave ink on the the clear plastic ring, So I have to wipe away the ink off it everytime is there any setting I can change in the program to stop this?- Acoustica Greg
- Posts: 24562
- Joined: Wed Mar 01, 2006 5:30 pm
- Location: California
- Contact:
Re: Printing on discs leave ink on clear plastic ring.
Hi,
If you are using a "Full" or "Full-faced" template in the Paper Type setting, try switching to the other template for your printer.
The full templates have a smaller center hole.
Greg
If you are using a "Full" or "Full-faced" template in the Paper Type setting, try switching to the other template for your printer.
The full templates have a smaller center hole.
Greg
Mixcraft - The Musician's DAW
Check out our tutorial videos on YouTube: Mixcraft 10 University 101
Check out our tutorial videos on YouTube: Mixcraft 10 University 101
Re: Printing on discs leave ink on clear plastic ring.
Alternately, you can adjust the size of the area printed.
-
- Posts: 2
- Joined: Fri Nov 04, 2016 3:41 pm
Re: Printing on discs leave ink on clear plastic ring.
It might be the case but not so often!HELLOHI wrote:Hi the discs I use are these below.
But everytime I print if always leave ink on the the clear plastic ring, So I have to wipe away the ink off it everytime is there any setting I can change in the program to stop this?