Pops On Punch In / Out
Moderators: Acoustica Greg, Acoustica Eric, Acoustica Dan, rsaintjohn
-
- Posts: 31
- Joined: Thu Jul 19, 2018 1:54 pm
Pops On Punch In / Out
I don't recall having this happen before and I've done a lot of punch in recording w loops on vocal tracks. Today, punching in a bass part I get an audible pop on the in and out points. I'm recording using takes, Behringer 1820 interface with latest asio driver, tried buffer on both 128 and 256 with the same results. Recording two tracks. CPU / System usage is minimal, I've also fully rebooted. Is there anything else I can check before I record the whole part AGAIN, gah! Oh and before I submit a ticket. Thanks in advance y'all.
MX 9 Pro, 64-bit. DIY PC w/ i5, Gigabyte Mobo, 16GB, Windows 10. DIY desk from HomeStudioGuy. Behringer 1820. M-Audio LX-4 monitors. Dyna-Bass 5-string. Strat w EMGs. Seagull acoustic. R0de NT1-A, Behringer C2. M-Audio controller. 27 miles of cable.
- Acoustica Greg
- Posts: 24740
- Joined: Wed Mar 01, 2006 5:30 pm
- Location: California
- Contact:
Re: Pops On Punch In / Out
Hi,
You would put a tiny fade at the start and/or end of the clips.
Or you could try turning on Mixcraft 9's microfade option for the clips that have pops.
Greg
You would put a tiny fade at the start and/or end of the clips.
Or you could try turning on Mixcraft 9's microfade option for the clips that have pops.
Greg
Mixcraft - The Musician's DAW
Check out our tutorial videos on YouTube: Mixcraft 10 University 101
Check out our tutorial videos on YouTube: Mixcraft 10 University 101
-
- Posts: 31
- Joined: Thu Jul 19, 2018 1:54 pm
Re: Pops On Punch In / Out
Thank you! This worked perfectly.
MX 9 Pro, 64-bit. DIY PC w/ i5, Gigabyte Mobo, 16GB, Windows 10. DIY desk from HomeStudioGuy. Behringer 1820. M-Audio LX-4 monitors. Dyna-Bass 5-string. Strat w EMGs. Seagull acoustic. R0de NT1-A, Behringer C2. M-Audio controller. 27 miles of cable.