Greetings all:
I hope someone can help, because I'm at my wts end. I've been using Beatcraft for a while now, but reently every time I create a rendering, there's a a measure or two of dropout somewhere in the middle of the track. Usually it comes after a crash symbol, a measure or two of dead air then the track starts up again. But it's not like the sound abruptly cuts out; it's more like purposefully placing a rest measure in the middle of the track, which I have not done.
I've tried adjusting the buffer, adding a new track where the dropout occurs, rendering under a different file format . . . nothing works. It's very aggravating. any suggestions will be greatly appreciated.
Thanks.
-L
Rendering dropouts
Moderators: Acoustica Greg, Acoustica Chris, Acoustica Eric, Acoustica Dan
- Acoustica Eric
- Site Admin
- Posts: 5802
- Joined: Wed Mar 22, 2006 4:30 pm
- Location: Michigan, USA
- Contact:
re
If you are using multiple tracks in the sequencer window, try condensing down to as few as possible. I did an entire cd using beatcraft, never using more than one track.
Acoustica Support
All my music is made with Mixcraft!
Eric Band (Infamous Quick) Site
Eric On YouTube
Eric On Facebook
Eric On Soundcloud
Eric On Reverbnation
All my music is made with Mixcraft!
Eric Band (Infamous Quick) Site
Eric On YouTube
Eric On Facebook
Eric On Soundcloud
Eric On Reverbnation